A06B-6105-H002 – FANUC Robotics R-2000iA Servo Amplifier
The FANUC A06B-6105-H002 is a servo amplifier used with the FANUC Robot Module R-2000iA. Usually, these amplifiers are factory set for operation, so you do not need to set or adjust them. However, if you need to configure or troubleshoot your A06B-6105-H002, please follow the instructions below. Take note that before touching your FANUC Robotic drives, you should always check the voltage at the screw above LED “D7” to ensure that the remaining voltage is not higher than 50V.
The following table highlights the various LEDs on the A06B-6105-H002 and their meanings.
|P5V||Green||Lights when the power supply circuit inside of the servo amplifier outputs a voltage of +5V normally.|
|P3.3V||Green||Lights when the power supply circuit inside of the servo amplifier outputs a voltage of +3.3V normally.|
|SVEMG||Red||Lights when an emergency stop signal is input to the servo amplifier.|
|ALM||Red||Lights when the servo amplifier detects an alarm.|
|RDY||Green||Lights when the servo amplifier is ready to drive the servo motor.|
|OPEN||Green||Lights when the communication between the servo amplifier and the main board is normal.|
|WD||Red||Lights when the watchdog alarm is detected in the servo amplifier.|
|D7||Red||Lights when the DC LINK circuit inside the servo amplifier is charged to reach a specific voltage.|
If you need to replace the A06B-6105-H002 amplifier on your R-2000iA, ensure that you begin by first turning off the control unit main power. Next, detach the amplifier cover and pull out the cable. Check the screw above LED D7 with a DC voltage tester to make sure the remaining voltage is not above 50V. Remove the two screws located on the top of the amplifier. At the middle top of the drive, there is an M5 screw that fastens the amplifier during the transport of the cabinet. After installation of the cabinet, remove the screw as this will help improve maintainability.
After these steps are complete, you can pull the amplifier toward you using the handles located at the top and bottom. Be careful not to touch any components on the lower part of the drive’s PCB, and try not to damage any cables routed under the amp when pulling it out. Use a slanted angle when pulling it out. MRO Electric and Supply has spare FANUC Robotics AC and DC Drives available. For more information or to request a quote, please email email@example.com or call 800-691-8511.
You can easily install a replacement by reversing the steps above. Lastly, be sure to check out our other robotics articles