UNI1405 Configuration and Setup

UNI1405 Model UniDrive

You can check out our previous blog post on the UNI1405 parameters and manual here with additional setup info. Check out our entire collection of Unidrives on our website.

With the UNI1405 configuration, the volts / frequency ratio must be kept constant to ensure rated torque is available from the motor over the frequency range. At low frequencies (from 0 Hz to ½ x Pr 5.06) the voltage is increased from this characteristic by a level governed by either the voltage boost parameter or the motor parameters (found during the stator resistance test) depending on whether the drive is in fixed boost or open loop vector mode as shown aside.

UNI1405 Motor Rated Power Factor

The power factor is found by the UNI1405 4kw during the autotune procedure. It is used in the open loop vector algorithm and to set the current limit levels for the torque producing (active) current.

Emerson UNI1405 4kw Motor Rated Speed

The motor rated speed parameter should be set to the synchronous speed of the motor minus the slip speed. This is often displayed on the motor nameplate. I.e. For a typical 18.5 kW, 50 Hz, 4 pole motor the motor rated speed is 1465 rpm. The synchronous speed for a 4 pole motor is 1500 rpm therefore the slip speed is 35 rpm Synchronous speeds for different numbers of poles are as follows:

2 pole = 3,000 rpm

4 pole = 1,500 rpm

6 pole = 1,000 rpm

8 pole = 750 rpm

The accuracy of this parameter is very important as it directly affects the torque produced at the shaft. Often the value given on the motor nameplate is not

100% accurate which can lead to a loss of torque.

For ordering info or a UNI1405 price you can call 1-800-691-8511 or email sales@mroelectric.com.

UNI1405 Configuration

Joe Kaminski

Joe Kaminski is an industrial automation specialist at MRO Electric. He has a background in industrial engineering and supply chain management. Joe has worked in the automation industry for over 10 years providing support to some of the largest companies in the world. For more info, visit www.mroelectric.com.

Next 140CPU43412A Configuration and Setup »

Previous « 6SN1123-1AA00-0EA1 Configuration and Setup

Published by

Joe Kaminski

Tags: Motors & DrivesSetup & ConfigurationUnidrive

9 years ago

MagneTek GPD503 Fault Codes
Below is a chart with fault codes regarding the MagneTek G3 GPD503 series drives. MRO…
Common UNI1405 Fault Codes
Below is a table of common Unidrive faults found within the Control Techniques Unidrive series,…
Yaskawa P1000 Fault Codes
Below is a table of common fault codes found on Yaskawa P1000 units. If problems…